An Introduction to the Controller Area Network (CAN) Bus

What you'll learn

Understand the commercial and technical factors that drove the development of CAN Bus

Understand the need for network arbitration and how it is done with CAN Bus

Know the format of the CAN Bus data frame

Gain an appreciation of the various parts of the CAN Bus data frame and their purposes

Understand how non destructive collision detection occurs at the byte level

Appreciate what part of the protocol is handled in firmware and what needs to be specified by the designer

Configure CAN Bus message identifiers and data format on actual CAN Bus hardware

Use CAN Bus simulation software to simulate a CAN Bus network

Requirements

Working knowledge of the process control devices in a typical Process Automation or SCADA system

Basic understanding of binary systems and computer memory

Description

CAN Bus stands for "Controller Area Network" Bus.

CAN-bus is one of those technologies that everyone experiences every day, without actually knowing about it. Because it is so widely used, in everything from cars and trucks through to boats, factories and even building management systems, the chances of interacting with it on a daily basis are pretty high.

CAN is a vehicle bus standard designed to allow microcontrollers and devices to communicate with each other in applications without a host computer. It is a message-based protocol, designed originally for multiplex electrical wiring within automobiles, but is also used in many other contexts.

You should get to know this protocol as it will allow you to expand your expertise and opportunities in design and building equipment in the following areas: Automotive, Medical, Military, Industrial Machines, Aviation, etc.

There is quite a bit of info on CAN Bus available on the Internet, but not much showing CAN Bus communications in a very practical way. And that's what I am going to do in the course.

At the end of my course, you are not only going to understand the CAN Bus theory but I am going to show you how to use CAN Bus hardware and software in my usual practical approach.

Who this course is for:

Electrical Eeers

Electrical Technicians

Electrical Tech or Eeering Students

Process Control Technicians and Eeers

Process Automation Eeers

Programmers working in the Process Automation field

Automotive Eeers

Automotive Technicians



DOWNLOAD
uploadgig


rapidgator


nitroflare